Baby Bottle Shaped Shaker Card

 Hello Crafty friends, today I want to share how I made this adorable Baby shaker card!

The file for my project today is the Baby Bottle Shaped Card (SVG, Silhouette).

I opened my file in Silhouette studio & took the bottle panel of my file, (coloured in white in my pic), & made a copy so that I now have 2. 

 

One will be used to create a frame for my shaker by making an internal offset & the other I will use to cut a sheet of acetate for the shaker window.

I created an internal offset of 0.450 on one of them. You can now put the other, (for the acetate), without the offset to the side. I have slightly enlarged my card so the offset measurements may vary depending on the size of your card. I just kept playing with mine till I got it to the desired size.

 

 I then copy & pasted this to fill my page. I was able to fit 4 in total. I cut out 12 pieces of this panel. These are to create the frame for your shaker. You only keep the outside frame. The insert is not needed. You will only need to cut 1 frame if you prefer to create the window frame with foam tape. I prefer this way as I find them much sturdier. I then cut out another of the same panel using the printed paper to make the top printed panel. This time keep both the frame & inside cut. Once I cut out all my pieces the first step was to glue the frame together by layering carefully my 12 pieces. 

How thick the layer will depend on the type of shaker confetti you use inside. My shaker balls where a little raised & I wanted them to move freely in my card.

Next I glued together my top panels onto the front of my bottle panel & also glued down the shaker frame I created onto the bottom part.

I wanted some embellishments as well as sprinkles in my card, so I adhered some cute stickers on the inside panel first. 

Once my stickers were in place I took the panel & glued it inside my frame. This should fit perfectly. Then I added my tiny balls. You can use any sprinkles in your stash. I wanted mine to look like milk inside the bottle that is why I chose the white balls. Next I gave my acetate a light brush of powder on the side I was going to glue down so that it is not static. I then glued the acetate to the frame. I let it dry before the next steps. Acetate takes a little longe to dry & not so instant as paper. Once the acetate was dry I glued on top the printed panel frame. Lastly I glued down my complete bottle panel onto the front of the card frame.

I added a sticker with sentiment on top to finish off!

Supplies:

Paper: Doodlebug Design - Bundle of Joy

SVG File: Lori Whitlock - Baby Bottle Shaped Card (SVG, Silhouette).

Accessories: Doodlebug Design Shakers - Lily White Balls & stickers.

For more inspiration, check out my Instagram!

Thanks for stopping by!

Hugs

Noelene :)